Local Advice

Retaining Walls in Timaru: Consent, Drainage and Stone Finishes

Last updated November 2026

Timaru is built on rolling ground, and plenty of sections step down from the street, slope towards a back fence or were cut and filled to make room for a house. A retaining wall turns that slope into usable space: a flat lawn, a level patio, a raised garden bed or a driveway that does not wash out in heavy rain.

★View the Best Garden Rock and Stone Suppliers in Timaru→

A retaining wall also holds back a lot of weight, so it is worth planning properly. This guide covers when you need a building consent in Timaru, the main types of wall, why drainage matters so much and how to give a wall a stone finish.

Do You Need a Building Consent?

Under Exemption 20 in Schedule 1 of the Building Act 2004, a retaining wall does not need a building consent if it retains no more than 1.5 metres depth of ground and does not support any surcharge. MBIE’s guidance on building work that does not need a consent explains the conditions in detail.

Types of Retaining Wall

Timber pole and rail

How it works
Treated timber posts set in concrete, with horizontal rails behind them
Good to know
Common for garden walls; posts are usually H5 treated and rails H4 for ground contact

Concrete block

How it works
Reinforced, concrete-filled masonry blocks on a concrete footing
Good to know
Strong and long lasting, and a good base for a stone or plastered finish

Interlocking or keystone block

How it works
Stacked precast blocks that lock together, often set back slightly as they rise
Good to know
Suits DIY garden walls at lower heights; follow the maker’s height limits

Gabion

How it works
Wire mesh baskets filled with rock
Good to know
Free draining with a natural, rocky look; needs room for the baskets

Natural stone

How it works
Dry-stacked or mortared stone
Good to know
A traditional look that takes skill to build well, especially as height increases

For a low garden wall, timber and interlocking block are the usual DIY choices. Taller walls, walls on a boundary and walls near buildings or driveways are better left to a builder or landscaper, with an engineer involved where needed.

Drainage: Why Walls Fail

Water is the main enemy of a retaining wall. When soil behind a wall gets saturated it becomes much heavier and pushes harder against the wall, and in winter that wet ground can also freeze and expand. Many walls that lean, bulge or crack do so because water was never given a way out.

Giving a Retaining Wall a Stone Finish

A concrete block wall does the structural work well, but bare block is not much to look at. Many people finish the face with stone so the wall looks like part of the garden rather than a piece of infrastructure.

Before You Start

  • Find your boundaries. A wall on or near a boundary affects your neighbour, and the footing, backfill and drainage all need to stay on your side.
  • Locate underground services. Use beforeUdig to check for cables and pipes before any digging.
  • Think about access. Getting a digger, drainage metal and block or stone to the back of a section is often the hardest part of the job.
  • Plan the finish early, so the footing, the wall and any stone facing are designed together.

Where Classic Stone Fits

Classic Stone, a New Zealand owned company established in 2000, makes stone veneer at Winchester, just north of Temuka, and supplies it for retaining walls, planter bins and entrance ways as well as houses and fireplaces. The veneer is lightweight, at 30 to 50kg per square metre, so it needs no additional footing or wall ties, and it goes over concrete block, brick, precast panels and fibre cement sheet. Classic Stone says planter bins and retaining walls can be faced by any competent tradesperson or handyman, and it can give detailed instructions.

Profiles include Southern Ledgestone, Colonial Schist, River Stone and New Zealand Basalt. To see them in person, request samples through the website or call (03) 688 7036.